10-01-2018 03:45 PM
OK,
I read on another site that turning off the Thumnail View in ScanGear lets you adjust the input cropping for the slides. Yay! But it does not seem to remember these settings, even if i save them to a new profile. Am I doing something wrong or is the software just retarded? It will be very painfull to manually crop a few hundred slides, especially when the auto detect guesses differently about each slide size.
10-01-2018 04:23 PM
Hi SlideBoy,
I'm afraid that the software does not retain cropping settings, as not all images will be cropped in exactly the same way, and even the same image can be cropped in different ways. I regret any inconvenience.
This didn't answer your question or issue? Please call or email us at one of the methods on the Contact Us page for further assistance.
Did this answer your question? Please click the Accept as Solution button so that others may find the answer as well.
12/05/2024: New firmware updates are available.
EOS R5 Mark II - Version 1.0.2
09/26/2024: New firmware updates are available.
EOS R6 Mark II - Version 1.5.0
07/01/2024: New firmware updates are available.
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.