cancel
Showing results for 
Search instead for 
Did you mean: 

Re: MX922 Printer has error code 6001 that won't resolve

brservicescorp
Apprentice

Instructions say to turn off, unplug, replug.

Have done this several times to no avail.

The paper tray was not closed when this message appeared - we only close it when adding paper to tray.

Anything else we can try?

2 REPLIES 2

Caemene
Rising Star

Hi brservicescorp,

 

The 6001 support code indicates the paper output tray is closed. Opening the tray should resolve the support code.

 

In the event that the support code remains perform a power reset, the following steps will assist you:

 

  1. Disconnect the power cord from the printer and outlet.
  2. Press the power (On/Off) button on the printer 5 times.
  3. Each time you press the power (On/Off) button, hold it down for approximately 3 seconds.
  4. Leave the printer disconnected for approximately 10 minutes.
  5. After the time has passed, reconnect the power cord to the printer.
  6. Connect the power cord directly to the wall outlet.
  7. Open the output tray.
  8. Turn the printer on.

 

 

Thank you for your help, but it didn't work.  Have tried three times.  Maybe I'll just turn it off and try again tomorrow.

Regards, Jen

Announcements
06/30/2022: Service Notice: EOS 70D: Error 70 or Error 80
06/10/2022: Service Notice:UPDATE: Canon Inkjet Printer continuous reboot loop or powering down
06/07/2022: New firmware version 1.3.2 is available for PowerShot G7 X Mark III
06/07/2022: New firmware version 1.0.3 is available for EOS M50 Mark II
05/31/2022: Did someone SAY Badges?
05/26/2022: New firmware version 1.0.5.1 is available for EOS-C500 Mark II
05/26/2022: New firmware version 1.0.3.1 is available for EOS-C300 Mark III
05/10/2022: Keep your Canon gear in optimal condition with a Canon Maintenance Service
05/05/2022: We are excited to announce that we have refreshed the ranking scale within the community!
04/26/2022: New firmware version 1.0.1.1 is available for EOS R5 C
03/23/2022: New firmware version 1.0.3.1 is available for EOS-C70
03/22/2022: New firmware version 1.2.0 is available for PowerShot PICK
03/16/2022: New firmware version 1.5.2 is available for EOS-R5
03/16/2022: New firmware version 1.5.2 is available for EOS-R6
02/09/2022: Share Your Photos is back!
02/07/2022: New firmware version 1.1.1 is available for EOS-R3
02/07/2022: New firmware version 1.6.1 is available for EOS-1DX Mark III
01/19/2022: READY FOR ANYTHING EOS-R5 C
01/13/2022: Community Update. We will be retiring the legacy profile avatars on 01/20/2022. Click this link to read more.
01/05/2022: Welcome to CES 2022!
12/7/2021: New firmware version 1.3.0 is available for Mount Adapter EF-EOS R 0.71x
12/7/2021: New firmware version 1.1.1 is available for CR-N 300
12/7/2021: New firmware version 1.1.1 is available for CR-N 500
12/2/2021: New firmware version 1.1.0 is available for RF 70-200 F4 L IS USM