12-30-2020 04:24 PM
My late friend left a unused Pixma MG2922 to me. I down loaded the software to set up Windows 10 & tried to set up. Of course it's past the support period & I'm abt to tss it in alley!
The green on light & the amber alarm light alternately flash twice. I checked the paper jams, none. Put new ink cartridges in correctly & removed the protective tapes. I've turned it off unplugged it, clx any printing jobs, & the cartridges clicked into place. I've turned it on again & led's continue to flash.
Any suggestions?
12-30-2020 05:38 PM
Two orange flashes separated by a long green flash means there is no paper in the tray that is selected. If there is paper, then the feed switch is probably set to the wrong source.
12-30-2020 05:45 PM
Thanks but the green on light flashes, then the amber light, then the green on light flashes & the amber light flashes. Then the light remains on for a few seconds. So to summarize green led, amber led, green led, amber led .
Any suggestions?
12-30-2020 08:24 PM
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
EOS 1DX Mark III - Version 1.9.0
12/05/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.3.0
07/31/2023: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.