cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

PIXMA iP7250 prints "shadow/double" letters, words, sentences, etc... making the text unreadable

northern-servic
Apprentice
 
43 REPLIES 43

It's now been a few months since my last post and Canon have still not acknowledged that this is a common fault.  Their only advice is to take the printer to a service centre where they will quote to have it repaired. 

 

I have communicated with a service centre and they have advised that they have never seen any similar faults and have no idea what the fault may be without further investigation, however I will have to pay for any such investigation.

 

According to other posts, this is the common scenario and the general response is that the printer is 'not worth repairing'.  I have not yet seen any conclusive information which identifies the root cause of the fault.

 

This means that we are in a hopeless situation.  Canon won't investigate further or acknowledge the fault and their repair centres simply advise to get a new printer.

 

This isn't good enough Canon !!

Raad
Apprentice

Exact the same problem !!

  • Canon Pixma MX922
  • Windows 10 64bit
  • I have used both WiFi and USB
  • I have done all suggestions

Please help me !!

tgabrielli
Contributor

Same problem here. If I can't find a solution, will ditch the printer and go with one from HP.

Same here... I've tried for over a year to figure it out on wi-fi MX 922.  Trying suggestions that don't work. Frustrated.

Obviously, Canon is keeping a deaf ear on this subject and refuses to offer a solution or adequate offer. So much for customer support. MY solution: get an HP or a Brother and ditch Canon. Forever. Printers are not that expensive. It just bugs me that I just went out and puurchased 3 new sets of ink for the Canon printer, which are now useless.

Hello,

 

OMG I did it.

Sorry for my english. 

My printer works much better now.

Sorry- it's in Czech languague.

You have to set up printer head MANUALLY !!!

Go to printer settings and something like "maintenance". ETC as per pictures. Let me know, if it helps.

 

Výstřižek.PNG

Výstřižek2.PNG

 

Výstřižek3.PNG

 

 

 

 

Manual alignment works for some people, however it doesn't work in all cases. In my case, some of the settings are +5 but the alignment is still out.  They would probably need to be +10 but you can't enter values that high and so the head never aligns.

tgabrielli
Contributor

Where is Canon's response to this problem??? Has anyone heard from them about this?

All attempts by myself so far to get Canon to acknowledge that this is a common fault and investigate it further have failed. 

 

Canon simply direct consumers to their repair centres to 'evaluate' the problem at the consumer's cost and the repair centres recommend printer replacement because replacement parts would exceed the cost of a new printer.

We have two Canon printers, MG5650 and MX450 and on both printers is the same problem after approx. 4,5 years.

Announcements