08-03-2023 07:24 PM
As stated above, my barely 1 yr. old printer is now pushing the top margin down. Today, I had to set top margin at 0.5" in Win10 Word for it to print at little over 1". Goal is 0.75". At 0.75" set, then it prints starting about 1.5" down on the page.
For troubleshooting, I turned the printer off and back on again. Then ran a print head alignment.
Will reloading the software take care of it?
Solved! Go to Solution.
08-03-2023 09:36 PM
Reloaded the printer software and that took care of it.
I was hoping it would just be a software thing because it didn't do that before I reloaded Win10.
08-03-2023 09:36 PM
Reloaded the printer software and that took care of it.
I was hoping it would just be a software thing because it didn't do that before I reloaded Win10.
12/05/2024: New firmware updates are available.
EOS R5 Mark II - Version 1.0.2
09/26/2024: New firmware updates are available.
EOS R6 Mark II - Version 1.5.0
07/01/2024: New firmware updates are available.
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.