02-12-2015 04:11 AM
My MG7610 works flawlessly as a wireless network printer and prints brilliant photographs. But in recent times it has dveloped an irritating fault. When you turn it off it displays the message "Ending... Please wait a while." Then it refuses to quit - I've waited over 2 hours before giving up and pulling out the plug. Then I get the warning about turning off properly.
I have followed advice on this forim: "Unplug, push the On/Off button 5 times and wait 30 mins before plugging in again" This seems to fix the problem for a while, then the shut down problem happens again. Is it a driver problem? A firmware problem? Any suggestions welcome.
02/20/2025: New firmware updates are available.
RF70-200mm F2.8 L IS USM Z - Version 1.0.6
RF24-105mm F2.8 L IS USM Z - Version 1.0.9
RF100-300mm F2.8 L IS USM - Version 1.0.8
RF50mm F1.4 L VCM - Version 1.0.2
RF24mm F1.4 L VCM - Version 1.0.3
01/27/2025: New firmware updates are available.
12/18/2024: New firmware updates are available.
EOS C300 Mark III - Version 1..0.9.1
EOS C500 Mark II - Version 1.1.3.1
12/05/2024: New firmware updates are available.
EOS R5 Mark II - Version 1.0.2
09/26/2024: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.