11-05-2017 02:17 PM - edited 11-05-2017 02:35 PM
Hi,
I have a MG3120 multifunction printer and I have an issue I haven't been able to solve.
- On every printed page (from any source, i.e., Web, word docs, etc) the printing doesn't start until about 1.5 inches down the page. I have ran through the head alignment and i thought the step where you place the printed page in the scanner would resolve the issue, since the scanner should "see" that the alignment arrow on the upper corner is about 1.5 inches down the page. It's almost as if it's feeding the page too far before starting to print.
Any ideas??? Any suggestion is welcome, as my next step is to get rid of it.
Thank you.
11-08-2017 02:23 PM
11-08-2017 02:26 PM
12-27-2017 02:00 PM
Hello.
Troubleshooting with our support group will be needed to narrow down the cause of your issue. Please contact our support group using the "Contact Us" link below for additional assistance.
This didn't answer your question or issue? Find more help at Contact Us.
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
EOS 1DX Mark III - Version 1.9.0
12/05/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.3.0
07/31/2023: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.