01-20-2020 09:38 AM - edited 01-20-2020 09:42 AM
I'm not sure about my recently aquired HF G50. I am having trouble with 4K video and some of the programmed settings.
4K recording is very stuttery as is the low lite and nite settings in HD/manual mode. I'm thinking its something to do with the write to the SD card speed but I think I have fast enough cards 128gb/170mb/s class 10 sandisk. I tried it in dual record and relay modes...same thing happens.....stuttery or buffering bahaviour. Wondering if I missed something in setup.... any suggestions out there? Thanks in advance
ps/ I think the HD high frame rate recordings are just fine but so far I spent more time trying to figure out the disappointing 4k to log enough HD time to review completely
Solved! Go to Solution.
02-23-2020 08:00 PM
The SanDisk SDXC cards rated at U3 Class 10 are ample for this camcorder. I'm using both the older 95 MB/s cards as well as newer 170 MB/s ones. Note that those are the typical read speeds; write speeds are a bit slower. However, these ratings are in mega _bytes_ per second and not megabits. Note that the bit-rate for 4K in the G50 is 150 Mb/s. So divide by 8 to get MB/s which is around 19 MB/s (far below the card's write speed; even at sustained writes).
Be sure to fully format the cards in-between major recording sessions. Cards that become fragmented can slow down.
When you mention that the 4K video is very stuttery, what was the frame rate? Also, what stabilization mode were you using? Note that if you have stabilization mode on while also using a tripod, that can lead to issues.
When playing the video back, what is the refresh rate of your display? I record in 23.976p and use displays with proper pulldown. Sometimes if using the wrong settings in post, you can end up with jitter as well.
09-30-2020 05:26 PM
i bought a g50 for videoing R/C planes. i am very disappointed in the pixilation and the stuttering . i had an old sony 1080i camera that was better than this camera. doesn't sound like there's any fix to it. i'm referring to recording in 4k . Memory care is what's supposed to be in it . a real let down. canon should make it right . i've used this camera only about 5x's . i bought it because i had such great luck with my T5i .
03-29-2023 12:59 PM
This thread is sad. The "solution" is to buy a G60 and get rid of your G50.
02/20/2025: New firmware updates are available.
RF70-200mm F2.8 L IS USM Z - Version 1.0.6
RF24-105mm F2.8 L IS USM Z - Version 1.0.9
RF100-300mm F2.8 L IS USM - Version 1.0.8
RF50mm F1.4 L VCM - Version 1.0.2
RF24mm F1.4 L VCM - Version 1.0.3
01/27/2025: New firmware updates are available.
12/18/2024: New firmware updates are available.
EOS C300 Mark III - Version 1..0.9.1
EOS C500 Mark II - Version 1.1.3.1
12/05/2024: New firmware updates are available.
EOS R5 Mark II - Version 1.0.2
09/26/2024: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.