Canon Community

longinthetooth · 01-05-2016

Hello everyone,My 700d (T5i) still has the original firmware 1.1.1. I see that the most recent version is 1.1.4. I have also found a 1.1.3 version, but not a version 1.1.2.Am I correct in assuming that I should not update 1.1.1 directly to 1.1.4 but ...

longinthetooth · 02-28-2015

Hi there,I wondered if anyone could give me the benefit of their experience. I have bought a used 9950f scanner which worked the first time I used it (with a 32 bit Vista laptop and canoscan Toolbox 4.932 and Scangear 10.324a). To my dismay, a few mi...

longinthetooth · 01-09-2016

Thank you - job done!JB

longinthetooth · 05-29-2015

Thanks for your reply dindidit and sorry for not noticing it sooner. I have a windows 8.1 64 bit laptop and have tried to run the 9500f in windows 7 and vista compatibility mode without success thus far. Scangear shows an error message "Unable to op...

longinthetooth · 03-04-2015

Thanks for letting me know that Jenine - I'm aware how out of warranty this product is, and that I'm on the other side of the pond so was unlikely to trigger "official" support but I did wonder if someone with experience of this scanner might give me...

longinthetooth · 03-02-2015

A little more info. I have now managed to scan both photos and negatives but after scanning a few I find the scanner does not complete its movement back to its home position and I have to switch off, then on again. The scanner then completes its cycl...

Canon Community

User Statistics

User Activity

T5i firmware question

Canoscan 9950F

Re: T5i firmware question

Re: Canoscan 9950F

Re: Canoscan 9950F

Re: Canoscan 9950F