I think I may have discovered a problem in the firmware update procedure for upgrading to FW 1.0.3.1. I just completed the upgrade from 1.0.2.1 to 1.0.3.1 and then reloaded my saved menus. All went well, it took about 10 minutes for the firmware to u...
The FW update completed without any problems. It was the copy of my v1.0.2.1 menus into the camera from an SD card that over-wrote the new Canon709 color profile.
Natalya, Your statement contradicts the instructions that come with the firmware update and is not a solution for my situation after following those instructions.
Where can the “Canon 709” custom profile parameters be found? There are quite a few parameters that would have to be manually updated to replicate a particular custom profile.
Did you copy in your menus from an SD card after you did the FW update?? If you did, your old CP9:[USER09] over-writes the new “Canon 709” profile which installs as CP9:[CANON 709] created by the FW update. If you checked immediately after the FW upd...