problem with my new Pixma MG7720...
I can't figure out how to set and load the printer for a small size paper (and save that so I don't have to work so hard each time)..
I need to print a paper (envelope) that is 5.75w x 4.375h...
I set up a new “form” (per instructions for Publisher 2003, in Control * Printer * Printer Server), I also set up a half letter size, the Half Letter did save and shows in the selection options for “Page Setup * Paper * Size”, but “new form” “Envelope Kelly” (size above) does not show on the list for selection (though the drop list window is too small to read size of papers... there is a design flaw......)
using “custom” I thought I had it set up but printed 1" down from top, when I had margins set for .25 margin.... printed some marking lines on the next (full sheet), on preview, though set for small size shows a marked full page....no way to tell the window to print “1”
... frustrating... it also pulled in an envelope it didn't print, then partially printed that and half a page of letter when I next printed...
I miss my MP600!!!... maybe it couldn't print pictures from across the building, but it could print a piece of paper the size needed.... help! what am I missing in the manual?
lots of emails to Canon... no help....
I hope I didn’t just purchase a printer (nice print quality!) that cannot do what my 10 year old MP600 could do... print on a “non standard” piece of paper.... these envelopes are for my gift certificates... I can’t redo all the certs... and, I used to preprint my deposit slips... also a non standard size...
is there something in Publisher... or printer... that will not accept the decimal sizes? is there a way to tell the printer a different size, and have it still print the size given?
help!
