06-19-2025
03:37 PM
- last edited on
06-20-2025
10:16 AM
by
Danny
I use Quicken for windows to print checks. There are three checks per page. If I print one check, I have 2/3 of a page (2 checks) left for next time. Later, when I print those two checks, the MF642cdw resets the print area to 2/3 of a page because that's all that went through the tray. Anything I print later, from any source only prints 2/3 of the page on a full 8x11 sheet of paper. The ink just stops printing. I have the printer set to print 8x11 paper. I've rebooted the printer. I have attached 2 docs. The first is what I am trying to print. The second is what actually prints. What can I do?sent to printer
this is all that comes out
03/18/2025: New firmware updates are available.
EOS R5 Mark II - Version 1.0.3
02/20/2025: New firmware updates are available.
RF70-200mm F2.8 L IS USM Z - Version 1.0.6
RF24-105mm F2.8 L IS USM Z - Version 1.0.9
RF100-300mm F2.8 L IS USM - Version 1.0.8
RF50mm F1.4 L VCM - Version 1.0.2
RF24mm F1.4 L VCM - Version 1.0.3
01/27/2025: New firmware updates are available.
12/18/2024: New firmware updates are available.
EOS C300 Mark III - Version 1..0.9.1
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.