06-10-2016 02:27 PM
Hi -
I have a Canon ImageClass 6160 printer. I have been using this printer for 2 years without a problem. Recently it started to go into energy saver mode and won't wake up. I have to turn the printer off for at least 5 minutes, turn it back on, and then it begins to print the jobs I had previously sent.
I have read similar posts on the forum, but cannot figure out the problem. I currently have a Netgear Nighthawk X6 router - I am not sure if something in the router settings changed during a recent reboot that is causing this problem.
thank you for your help.
Solved! Go to Solution.
06-13-2016 10:07 PM
Get to this screen. Set the printer to "printer" in the dropdown and you are good. That's my printer at the bottom of the screen.
06-16-2016 10:57 PM
Sure happy to help!
11-11-2019 04:04 PM
Hi,
I have a Netgear Orbi and logged in like you said and the printer is set to printer, but still doesn't wake from eco mode.
Any thoughts?
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
EOS 1DX Mark III - Version 1.9.0
12/05/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.3.0
07/31/2023: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.