11-08-2024
01:03 AM
- last edited on
11-08-2024
08:11 AM
by
Danny
I have been facing an issue with EoS1500D camera. Below mentioned the test setup and issue.
Setup: I am using a dummy battery (ACK-E10) in the battery slot of an EOS 1500D camera to keep the camera (and display) continuously ON. I have disabled the auto power-off feature in the settings, but after 30 minutes, the camera still goes into auto power-off mode and the display turns off. I tried turning off and then on the ACK-E10 power adapter, but the camera's display did not turn back on. Could you please assist in ensuring the display stays on, even after cycling the power?
11-09-2024 04:35 AM
This behaviour is by design and it is mentioned in the manual on page 185 where it says:-
Even when [Disable] is set, if the camera is not used for 30 minutes the LCD monitor will turn off automatically. To turn on the LCD monitor again, press the <DISP> button.
12/18/2025: New firmware updates are available.
11/20/2025: New firmware updates are available.
EOS R5 Mark II - Version 1.2.0
PowerShot G7 X Mark III - Version 1.4.0
PowerShot SX740 HS - Version 1.0.2
10/15/2025: New firmware updates are available.
Speedlite EL-5 - Version 1.2.0
Speedlite EL-1 - Version 1.1.0
Speedlite Transmitter ST-E10 - Version 1.2.0
7/17/2025: New firmware updates are available.
02/20/2025: New firmware updates are available.
RF70-200mm F2.8 L IS USM Z - Version 1.0.6
RF24-105mm F2.8 L IS USM Z - Version 1.0.9
RF100-300mm F2.8 L IS USM - Version 1.0.8
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.