04-03-2013 09:18 PM
Where do I find the battery that runs the time and clock in my power shot SX20 IS?
04-08-2013 07:18 AM
gorja55,
The date/time battery holder is located on the inside edge of the battery compartment in the battery tube nearest to the tripod mount. To replace it, remove the batteries from the camera, then slide the holding tray out and install a new CR1220 lithium battery.
If this is a time sensitive-matter, additional support options are available at Contact Us.
04-08-2013 08:26 PM
thank you. I saw that but the writing is so small was not sure if that was it or not. how often do you think a person should change these batteries?
07/01/2024: New firmware updates are available.
06/06/2024: New firmware updates are available.
EOS R6 Mark II - Version 1.4.0
Speedlite EL-5 - Version 1.1.0
Speedlite Transmitter ST-E10 - Version 1.1.0
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.