11-17-2020 10:51 AM
I've entered maintenance mode of the printer (stop + power button, pressed stop 4 times while holding power).
Then I powered off the printer. And now it won't turn back on. Is the printer bricked or can I somehow turn it back on?
11-18-2020 03:46 AM - edited 11-18-2020 03:46 AM
Oops, the power cable was loose. Now I get error 5B00, but this should be fixable, right?
12/05/2024: New firmware updates are available.
EOS R1 - Version 1.0.1
EOS R5 Mark II - Version 1.0.2
09/26/2024: New firmware updates are available.
EOS R5 - Version 2.1.0
EOS R6 - Version 1.9.0
EOS R3 - Version 1.8.0
EOS R7 - Version 1.6.0
EOS R10 - Version 1.6.0
EOS R6 Mark II - Version 1.5.0
EOS R8 - Version 1.4.0
EOS R50 - Version 1.3.0
EOS R100 - Version 1.1.0
Powershot V10 - Version 1.3.0
07/01/2024: New firmware updates are available.
CR-N700 - Version 1.4.0
CR-N500 - Version 1.5.0
CR-N300 - Version 1.5.0
CR-N100 - Version 1.1.0
CR-X300 - Version 1.3.0
RC-IP1000 - Version 1.1.0
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
