01-05-2023 05:52 PM
I just bought this printer and hooked it up. I am using Debian Bullseye with Xfce 4.16. I loaded the Linux software that was available for download.
CUPS sees the printer and it printers nicely. The scanner software on my system finds the printer and it scans well.
However, I attempted to print a five page government document in long-side duplex mode, and ran into what appears to be a memory problem. It printed the last page, and then pages three and four. Then it started on pages one and two by printing page two and then pausing before pulling the paper back in for the first page. But then it just stopped with the page in the printer.
After about fifteen minutes, it spit it out with only the bottom one-fifth of the page printed.
Does anyone know why?
05/31/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.1.2
05/18/2023: New firmware updates are available.
EOS Rebel T100 - Version 1.1.0
EOS 5D Mark IV - Version 1.4.0
EOS 6D Mark II - Version 1.2.0
PowerShot Elph 360HS - Version 188.8.131.52
PowerShot SX420 IS - Version 184.108.40.206
PowerShot 620 HS - Version 220.127.116.11
PowerShot SX720 HS - Version 18.104.22.168
PowerShot G1X Mark III - Version 22.214.171.124
PowerShot G7X Mark II - Version 126.96.36.199
PowerShot G9X Mark II - Version 188.8.131.52
04/20/2023: New firmware version 1.4.1 is available for EOS R3
03/30/2023: New firmware updates are available.
EOS 1DX Mark III- Version 1.7.1
Speedlite EL-1 - Version 1.0.2
03/30/2023: Product Advisory for EF50 F1.2 L USM
03/30/2023: Product Advisory for EOS R10
2/07/2023: New product announcements!EOS R8 EOS R50RF-S55-210mm F5-7.1 IS STMRF24-50mm F4.5-6.3 IS STMRF15-30mm F4.5-6.3 IS STM
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.