12-03-2015
12:11 PM
- last edited on
12-06-2022
09:29 AM
by
Danny
Does anyone know how to reset the default automatic margins on Canon PIXMA MG2500 series driver?
I've been changing all margins on my documents to 0cm, but there ll be always margins showed up when I printed the documents, especially the bottom so it's always cutting off the bottom of the page. So I know it must be the driver. The automatic margin that always showed up on the bottom of the page is around 1,6 cm. There's also no option on the Printing Preferences to change them. I'm using Windows 10, by the way.
12-09-2015
08:46 AM
- last edited on
12-05-2022
05:40 PM
by
Mike
Hello.
If parts of the docment are being cut off rather than condensed in to the printout, the issue may be related to the program that is being used.
Try using a different program. If you are printing from the web, be sure to use the "print" option in or around the article to properly format the page for printing.
If you continue to have difficulties with this issue, find more help at http://canon.us/SupportCF
05-30-2016 04:03 PM
Well, No matter what program I am trying to print from, this happens. I noticed it as soon as I began using this printer. It seems that the page is "pushed up" so the full page never prints. I have experience dealing with printer settings, as well as formatting documents in MS programs as well as Adobe products, including Photoshop.
This is the printer. It needs a setting to adjust were the printer thinks the margins are. I have never had a printer that didn't allow this. Very annoying.
08-14-2016 01:22 PM - edited 08-14-2016 01:23 PM
I'm having this same issue with my brand new MG2900 series. I'm trying to use Microsoft Publisher and I cannot for the life of me, get it to stop cutting off the bottom of the page. Both Publisher and the Printer properties are showing 8.5 x 11. It's even cut off in the Print Preview.
Has anyone found a solution to this yet?
08-17-2016
11:06 AM
- last edited on
12-05-2022
05:39 PM
by
Mike
Hello.
Troubleshooting with our support group will be needed to narrow down the cause of your issue. Please contact our support group using the "Contact Us" link below for additional assistance.
This didn't answer your question or issue? Find more help at http://canon.us/SupportCF
12-05-2022 05:15 PM
That CONTACT US link sends you to a page that says the link is broken.
12-05-2022 05:38 PM
Thank you for pointing that out!
We'll update that old link with this current one: http://canon.us/SupportCF
Thanks again!
09-10-2016 05:03 PM
08-03-2017 02:05 PM
My exact same problems. You stated it exactly!
08-03-2017 02:12 PM
07/01/2024: New firmware updates are available.
06/06/2024: New firmware updates are available.
EOS R6 Mark II - Version 1.4.0
Speedlite EL-5 - Version 1.1.0
Speedlite Transmitter ST-E10 - Version 1.1.0
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.