11-16-2014 12:02 AM
My MX922 did print about 600 color pages and could not print very clear. Then I did a few time of clean/deep clean from maintenance. The test pattern is ok for PGBK. However, there is no color (or a little color once a while). All the colors ink could be detected. Is there anything that I could do now? Or the color printhead is bad? If this is the case, could you I chang that?
Thanks,
TJ
11-19-2014 12:55 AM
Hi tjs,
Since the cleanings did not improve the print quailty, please perform an automatic and manual print head alignment to see if this will help. To do this, please follow the steps located at the link below:
If you still experience difficulty after performing the alignments, the printer may require servicing; please call or email us at one of the methods on the Contact Us page to obtain your servicing options.
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
EOS 1DX Mark III - Version 1.9.0
12/05/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.3.0
07/31/2023: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.