Hi stav,
First, please identify the IP address that was assigned to your MAXIFY MB2720:
1. Press the HOME button on your MAXIFY MB2720.
2. Swipe the screen and select Setup.
3. Select Device Settings.
4. Select LAN settings.
5. Select Confirm LAN settings.
6. Write down the IPv4 address assigned to your MAXIFY MB2720.
7. Press the HOME button.
On your computer, please open a web browser and follow these steps:
1. Enter the IP address of your MAXIFY MB2720 that you wrote down in the address bar of the web browser.
2. Click Log On.
3. Enter the password. The password is the serial number of your MAXIFY MB2720. It can be found on the back of your printer.
4. Click on Device Settings from the menu on the left.
5. Click on Set mail server / test connect.
6. Select Set mail server.
7. Enter smtp-mail.outlook.com in the Outgoing mail server (SMTP) box.
8. Enter 587 in the Port number (SMTP) box.
9. Place a checkmark next to Secure connection (SSL).
10. Place a checkmark next to Don't verify certificates.
11. Select SMTP authentication under Authentication method.
12. Click OK at the bottom.
13. At the next screen, enter your Hotmail username (your_username@hotmail.com) and Hotmail password.
14. Click OK.
More information can be viewed in the MB2720's Manual here:
MB2700 > Changing Settings > Changing Printer's Setting Using Web Browser > Setting Mail Server
Also, the SMTP settings were obtained from Microsoft's web site:
POP, IMAP, and SMTP settings - Microsoft
Did this answer your question? If so, please click the Accept as Solution button below so that others may find the answer as well.
