05-23-2017 07:28 PM
Hello all, when I use duplex (two-sided) printing (set to high quality) on my Pixma MG7520 printer, I find my images printed are of a very low resolution. I realize this might be intentional, and that the printer might be trying to save ink as to not bleed through to the other side, however are there any settings I can change to prevent this? Should I use a different driver? Any thoughts? Thank you very much!
- John
Solved! Go to Solution.
05-26-2021 05:27 PM
If you only use black ink you can try by print options in the tab maintance to change ink cardridge-options to only black. Maybe a little late but i just figure this out 😛
05-24-2017 04:26 AM
Hi johncpatterson,
Click HERE for detail steps to perform to acheive the best quality duplex prints possible from the PIXMA MG7520.
If you continue to have difficulties, please contact our support group using the following link:
http://Canon.us/ContactLI
05-27-2017 08:38 PM
Thank you for your reply, however the instructions that you linked to do not refer to any settings that affect quality and/or images. Does anyone else have any ideas by chance?
Thanks!
- John
05-26-2021 05:27 PM
If you only use black ink you can try by print options in the tab maintance to change ink cardridge-options to only black. Maybe a little late but i just figure this out 😛
05-26-2021 05:37 PM
06/06/2024: New firmware updates are available.
EOS R6 Mark II - Version 1.4.0
Speedlite EL-5 - Version 1.1.0
Speedlite Transmitter ST-E10 - Version 1.1.0
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
EOS 1DX Mark III - Version 1.9.0
07/31/2023: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.