cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Canon mx318

LPI
Apprentice

Hello

 

My canon mx318 front door error, current position opended.

I tried to close then opened but still error, i tried to pickup a little bit run in seconds then error again.

lap by hand at right side also cant solve, please advise

thanks

1 REPLY 1

Ramona
Authority

Hi LPI,

 

To try and resolve the issue, please ensure that the printer is laying on a flat surface with nothing underneath it, and that the paper output tray has room to fully extend. You will also want to ensure that the Paper Thickness Lever is set to the left side if you are printing on any other type of paper other than envelopes or T-Shirt transfers; if printing on envelopes or T-Shirt transfers, you will want to have the Paper Thickness Lever set to the right side.   Hope this helps!

Did this answer your question? Please click the Accept as Solution button so that others may find the answer as well.
Announcements
01/18/2023: New firmware version 1.1.1 is available for EOS R6 Mark II
01/09/2023: Help ensure your autofocus is properly aligned with a Canon Precision Alignment
01/03/2023: Welcome to CES 2023!
12/08/2022: New firmware version 1.0.5.1 is available for EOS C70
12/07/2022: New firmware version 1.7.0 is available for EOS R5
12/07/2022: New firmware version 1.7.0 is available for EOS R6
11/22/2022: New firmware available for EOS R3, EOS R7 and EOS R10
11/16/2022: We're thrilled to be ranked among the Best Employers for Veterans in 2022 by Forbes.
08/31/2022: New firmware version 1.1.1 is available for RF 70-200mm L IS USM
08/09/2022: New firmware version 1.2.0 is available for CR-N 300
08/09/2022: New firmware version 1.2.0 is available for CR-N 500
07/14/2022: New firmware version 1.0.1 is available for CR-X300
06/10/2022: Service Notice:UPDATE: Canon Inkjet Printer continuous reboot loop or powering down
06/07/2022: New firmware version 1.3.2 is available for PowerShot G7 X Mark III
05/31/2022: Did someone SAY Badges?
05/26/2022: New firmware version 1.0.5.1 is available for EOS-C500 Mark II
05/26/2022: New firmware version 1.0.3.1 is available for EOS-C300 Mark III
05/10/2022: Keep your Canon gear in optimal condition with a Canon Maintenance Service
05/05/2022: We are excited to announce that we have refreshed the ranking scale within the community!
04/26/2022: New firmware version 1.0.1.1 is available for EOS R5 C
03/23/2022: New firmware version 1.0.3.1 is available for EOS-C70
02/09/2022: Share Your Photos is back!
02/07/2022: New firmware version 1.6.1 is available for EOS-1DX Mark III
01/19/2022: READY FOR ANYTHING EOS-R5 C
01/13/2022: Community Update. We will be retiring the legacy profile avatars on 01/20/2022. Click this link to read more.