11-06-2012 01:11 AM
My canon mx318 front door error, current position opended.
I tried to close then opened but still error, i tried to pickup a little bit run in seconds then error again.
lap by hand at right side also cant solve, please advise
11-08-2012 08:43 PM
To try and resolve the issue, please ensure that the printer is laying on a flat surface with nothing underneath it, and that the paper output tray has room to fully extend. You will also want to ensure that the Paper Thickness Lever is set to the left side if you are printing on any other type of paper other than envelopes or T-Shirt transfers; if printing on envelopes or T-Shirt transfers, you will want to have the Paper Thickness Lever set to the right side. Hope this helps!
05/31/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.1.2
05/18/2023: New firmware updates are available.
EOS Rebel T100 - Version 1.1.0
EOS 5D Mark IV - Version 1.4.0
EOS 6D Mark II - Version 1.2.0
PowerShot Elph 360HS - Version 184.108.40.206
PowerShot SX420 IS - Version 220.127.116.11
PowerShot 620 HS - Version 18.104.22.168
PowerShot SX720 HS - Version 22.214.171.124
PowerShot G1X Mark III - Version 126.96.36.199
PowerShot G7X Mark II - Version 188.8.131.52
PowerShot G9X Mark II - Version 184.108.40.206
04/20/2023: New firmware version 1.4.1 is available for EOS R3
03/30/2023: New firmware updates are available.
EOS 1DX Mark III- Version 1.7.1
Speedlite EL-1 - Version 1.0.2
03/30/2023: Product Advisory for EF50 F1.2 L USM
03/30/2023: Product Advisory for EOS R10
2/07/2023: New product announcements!EOS R8 EOS R50RF-S55-210mm F5-7.1 IS STMRF24-50mm F4.5-6.3 IS STMRF15-30mm F4.5-6.3 IS STM
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.