09-13-2024 11:46 AM
Hello! I have just purchased the canon Pixma IP8720 and completed the set up. I was prompted to complete a head alignment and when I went to do so, an orange light started to flash. I followed the recommended steps that the instructions provide for this occurrence but the orange light continues to flash. I looked it up online it was suggested that it may be an issue with the inks and how they are loaded. I opened the top of the printer but the ink tray did not move to align with where you load the inks. I turned off the printer and waited a few minutes before turning it back on. When I did, the ink tray again did not move correctly and got stuck on the opposite side of its "home base location" . I tried unplugging the printer and had the same issue with the ink tray.
I believe my flashing orange light is due to the inks not moving and being where they are supposed to be. I can not find any suggestions with this and attempted it utilize the chat function which I though would bring me to person to troubleshoot with, but was only provided an article that was not helpful. I do not see any error messages popping up, but again I am just setting this printer up and may not be looking in the correct locations for error messages.
If anyone has has a similar problem and was able to fix it, I would greatly appreciate any guidance with this
07/01/2024: New firmware updates are available.
06/06/2024: New firmware updates are available.
EOS R6 Mark II - Version 1.4.0
Speedlite EL-5 - Version 1.1.0
Speedlite Transmitter ST-E10 - Version 1.1.0
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.