08-02-2021 04:48 PM
I have the software working on 2 computers. Wonderful. On one computer, the camerawindow software starts automatically when the camera connects. On the other, it doesn't. I seem to recall that during installation on the "good" computer, I had an option to specify that the software start when the camera connects.
Now, on the "bad" computer, I can't find any setting anywhere that allows me the option of starting camerawindow automatically when the camera connects.
Is there a way to do this after all the software is installed?
08-02-2021 05:39 PM
What computer and operating system?
08-02-2021 05:46 PM
Both Windows 10.
08-02-2021 05:48 PM
The "bad" one has Norton 360. The other just has Institutional AV plus windows firewall.
05/31/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.1.2
05/18/2023: New firmware updates are available.
EOS Rebel T100 - Version 1.1.0
EOS 5D Mark IV - Version 1.4.0
EOS 6D Mark II - Version 1.2.0
PowerShot Elph 360HS - Version 220.127.116.11
PowerShot SX420 IS - Version 18.104.22.168
PowerShot 620 HS - Version 22.214.171.124
PowerShot SX720 HS - Version 126.96.36.199
PowerShot G1X Mark III - Version 188.8.131.52
PowerShot G7X Mark II - Version 184.108.40.206
PowerShot G9X Mark II - Version 220.127.116.11
04/20/2023: New firmware version 1.4.1 is available for EOS R3
03/30/2023: New firmware updates are available.
EOS 1DX Mark III- Version 1.7.1
Speedlite EL-1 - Version 1.0.2
03/30/2023: Product Advisory for EF50 F1.2 L USM
03/30/2023: Product Advisory for EOS R10
2/07/2023: New product announcements!EOS R8 EOS R50RF-S55-210mm F5-7.1 IS STMRF24-50mm F4.5-6.3 IS STMRF15-30mm F4.5-6.3 IS STM
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.