I have a pro 300 and ink is fairly heavy on the foam strip beyond the edges of the letter size I invariably use. I use kitchen paper and absorb it. MBK seems to be the primary culprit due to it being the one at the left hand end of the pro 300. Int...
I have been refilling Pro10 inks for years now and weighing them to check contents. For the pro10 18g empty and 32/33 g full. I fill them in situ on the scales and watch the weight increase until 32g then stop filling. Very reliable. In the case o...
I had this problem. The first time I was successful using distilled water (drained from my dehumidifier) or else use de-ionized water available form most car spares places, Add a small amount of dishwasher rinse agent (I used Finish) at about a te...
This what worked for me. Soaked the print head in distilled water (condensate from my dehumidifier) with a few drops of dishwasher rinse aid added. Rinsed it thoroughly and changed the water numerous times over four days, till the rinse ran clear. ...
In my case it is the red that does not flow. If I clean then run a nozzle check it is good, then a page or so later red becomes streaky or non existent. It happened after I left it for three months, powered off while I was away. i have removed and...
