11-20-2019 10:18 AM - last edited on 11-20-2019 10:22 AM by Danny
I have a idx mk 1 and my camera froze bringing up an error 20 code. I sent it away to get fixed and it came back after having the shutter box and a pcb board replaced. The fault happened again and this tie no message and a blank screen. The repair company have it back but have been unable to replicate the fault Any ides?
11-20-2019 11:47 AM
07/01/2024: New firmware updates are available.
06/06/2024: New firmware updates are available.
EOS R6 Mark II - Version 1.4.0
Speedlite EL-5 - Version 1.1.0
Speedlite Transmitter ST-E10 - Version 1.1.0
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.