10-27-2019 12:03 PM
I have tried several ways to print square (11x11") using my Pro-100 but each time the print comes out smaller, at approx. 7.5 x 7.5" I have tried this with both 12 x 12" and 13 x 19" paper loaded into the rear (top) feed.
My settings (in Lightroom) appear to be good for an 11.2x11.2" set-up. I have a template set up for 11.2 x 11.2 " printing. Also, I have checked on the paper size in page settings/print settings, and that seem to be set correctly as well. Does anyone have any suggestions as I am wasting a lot of photo paper!
10-27-2019 01:54 PM
These settings work fine for me.
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
EOS 1DX Mark III - Version 1.9.0
12/05/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.3.0
07/31/2023: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.