01-20-2017 10:29 PM
My IP4300 (yes it's older) recently started printing the first 70% of any color photo/print with Magenta streaked across the photo, then a 1/4" bold magenta stripe, and the last 20% prints great/correctly. This is not a stripe in the direction of paper travel, but rather across the width. SEE ATTACHED JPG. Happens with all sizes, plain paper, etc. I have run all cleaning and alignment, but the results are always the same. Has anyone seen it? Solved it?
01-21-2017 09:37 AM
Hello.
If the issue persists after cleanings have been performed, troubleshooting with our support group will be needed to narrow down the cause of your issue. Please contact our support group using the "Contact Us" link below for additional assistance.
This didn't answer your question or issue? Find more help at Contact Us.
01-21-2017 10:34 AM
01-21-2017 11:38 AM
Hi rlambakis,
You'll want to make sure you're contacting Canon USA Support. There are a lot of companies online who proport to be Canon Support, however there is only one who is legitimately us! During the week, our US-based (every employee is right here in the USA) can be reached by phone at 1-800-OK-CANON (800-652-2666) from 10am to 10pm (ET). You can reach our email support team (also right here in the USA) anytime by heading to http://Canon.us/EmailCF
We hope this helps!
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
EOS 1DX Mark III - Version 1.9.0
12/05/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.3.0
07/31/2023: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.