05-04-2024 03:35 AM - last edited on 05-04-2024 08:20 AM by Danny
I like to use the multi-purpose tray of my Prograf 300 to test print on different materials.
Unfortunately, the "NailStickers" do not show up in the media list of the printer driver (Windows 11)
I tried to do this by selecting "Printable disc". That works very well, but you have the disc hole, which is not printed. I've found no solution to eliminate the print hole of the "Printable disc" media, so I tried to use the "NailSticker" media. But this media is not on the media list of the printer driver.
I wonder why it is so complicated to use the multi-purpose tray. All I like to do is print on a media I place in the tray.
Is there a way to print that way? If only discs are possible, is there a way to prevent the disc hole from not beeing printed?
Please check the sample picture. I printed the portrait directly on an aluminum disc.
Besides that annoying disc hole in the middle of the picture, everything is as I expected.
Please note: if you try to do this at home, please make sure to post-process the print with vernis! The print won't stick to the aluminum on its own Thanks for any advice!
#image prograf 300
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
EOS 1DX Mark III - Version 1.9.0
12/05/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.3.0
07/31/2023: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.