03-23-2024 10:19 AM - last edited on 03-23-2024 10:22 AM by Arthur
Hi,
The power went out in my house and I cannot reconnect my prograf 1000 with my McBookPro. I have tried: uninstalling and reinstalling the printer driver, disconnecting the printer power cord from printer (after powering down), powering down and restarting the computer, checking for updates on the OS (Ventura 13.6.1), going through the wireless LAN setup again.
When I attempt to print, I get an error message with check your pinter's operation panel or remote UI. When I disconnected and reconnected the printer, it powered back on and printer panel said that the printer was not shut off properly (which was the same message after the power went off in the house.)
Advice?
Ruth
05-09-2024 02:24 PM
Hi,
I recommend reaching out to Canon support. You will need to register your Canon gear HERE to access additional support options.
We look forward to hearing from you.
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
EOS 1DX Mark III - Version 1.9.0
12/05/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.3.0
07/31/2023: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.