01-13-2024 07:07 PM - last edited on 01-16-2024 09:29 AM by Danny
When installing the driver for Canon Pixma Pro 200 printer, I am unable to change the location into which the driver is installed. A page of instructions stating "This will take 54.1 MB of space on your computer." contains a button with "Change Install Location". This button does nothing to permit location change - instead it sends me back to the previous page beginning "Select a Destination" and "How do you want to install this software?". A two page loup ensues leaving no actual options to change the installation location. According the the Adobe Lightroom Classic forums, I need to install to my Modules folder. I a using a Mac running on Sonoma 14.2.1.
thank you -- Melody
01-14-2024 06:27 PM
Karenmelody,
You might want to ignore the Lightroom Classic forums and just let the installation software put the driver where it wants to. Give that a try and let us know if it works for you.
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
EOS 1DX Mark III - Version 1.9.0
12/05/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.3.0
07/31/2023: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.