10-09-2023 04:04 PM - last edited on 10-17-2023 01:16 PM by Danny
I really like my iPF6450. I'd love it if I could get some relief on printing multiple copies with cut sheets.
I knew when I bought it that it could only load 1 sheet at a time. But as I type this I need to keep getting up not only to load the next sheet, but, after 30+ seconds of it fiddling with the paper, to tell it that the paper length is, yes, still the same as the last print. Isn't there a way around this? A setting in the service mode perhaps? A software update?
Any help appreciated.
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
EOS 1DX Mark III - Version 1.9.0
12/05/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.3.0
07/31/2023: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.