05-20-2024 12:18 PM - last edited on 05-21-2024 10:51 AM by Danny
Hi.
I noticed a problem while printing form AutoCAD. When printing with setting " No space at Top or Bottom" the printer refuses to print because it thinks paper is too short. Even if drawing is 500 mm long but paper setting is 1000 mm. Is there any solution.
kszyho
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
EOS 1DX Mark III - Version 1.9.0
12/05/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.3.0
07/31/2023: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.