12-19-2022
03:19 PM
- last edited on
12-19-2022
03:47 PM
by
Stephen
Hello all,
I recently purchased my TA 20 and have set it up and done a few prints on some different media. No problems setting up the media themselves, but am curious how to set cut margins on rolls. When printing a poster on roll media, the printer feeds 9" out before starting the print, and then close to 10" out after the print finishes before cutting the roll. This is a costly waste of media. How do I adjust it to not feed so much media before cutting? I'm thinking an inch or 2 between print edge and cut is acceptable. As of now I am set up for Auto Cut. And I was trying to print from Adobe InDesign. Could it have something to do with Adobe Print Dialog?
03-14-2023 04:20 PM
This forum leaves a lot to be desired. So much for anyone gaining anything substantial here. Guess I'll stumble around in the dark some more.
03/02/2023: New Firmware Updates Are Available:
EOS R7 - Version 1.3.0EOS R10 - Version 1.3.02/07/2023: New product announcements!
EOS R8 EOS R50RF-S55-210mm F5-7.1 IS STMRF24-50mm F4.5-6.3 IS STMRF15-30mm F4.5-6.3 IS STMCanon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.