My newly bought tm-240 started to have issue just 1 month after buying, (roughly after 20-30 prints).
It prints really slow, and eventually got an error: Sgraster 1303 a required item has not been set.
This is very frustrating as it usually happened at the end of the print. I printed a big 24x30, and it got issue after 80% of finish. Lot of wasted ink and paper.
Software used: Free Layout Plus, Direct Print Plus, Professional print and layout.
I tested on both ios and win, the same issue.
I tested with wifi and cable, the same issue.
I believe the firmware is the newest 1.05
I reinstalled driver on ios and windows, problem still persists.
At this point I think the new firmware is the issue...but there's no way to reverse to the original one. I tried to factory reset but it still on the newest firmware.
