Printer Software & Networking
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Posts

Nothing in Associate Port

Hi, I am having a problem with my Canon MP560 printer. When I try to associate the printer with a port, nothing happens. Basically, when I use the Canon IJ Network Tool, I go to Settings --> Associate Port, but nothing pops up. Picture:Apparently it ...

No Driver.png
gkhsieh by Apprentice
  • 5330 Views
  • 4 replies
  • 0 likes

Resolved! iPad won't recognise Mg8250 as an air printer

When I try to print wirelessly from iPad it comes back with the message "no air printer found" Is there something I need to do with the printer to make this happen. I should probably first give a bit of background to my situation which may or may not...

johnip by Contributor
  • 5283 Views
  • 3 replies
  • 0 likes

Pixma 5320

Why is the printer reading offline when I try to print through wireless? I am running Windows 7 and this issue only started about a month or two ago. Help is needed!!! 

diver989 by Apprentice
  • 3301 Views
  • 2 replies
  • 0 likes

AirPrint Printer not found - PIXMA MG6220

I have a Pixma MG6220 and lately when I try to print from my iPhone 5, I get the message "AirPrint Printer not found".  I have the current firmware version along with the current iOS.  It was working for quite a while and then all of a sudden it stop...

Pixma MX410 wireless printing

I have three laptops, each one running Windows 8.1. Every couple of days or so, for the past year, I will lose connection with my Pixma MX410. Even though it's a hassle, on the laptops I can reinstall the drivers through Canon's website and be up and...

tiskey by Apprentice
  • 2863 Views
  • 0 replies
  • 0 likes

Issues connecting to my laptop

My Canon MX459 printer is wirelessly hooked up to every computer in our house, except for my laptop! All computers run on Windows - my laptop is on Windows 7, while the others are Windows 8. The issue occured after restarting our wireless router in o...

Both wireless and USB printing on a MX892?

I am currently printing from my computer to a new MX892 via a USB cable. I was afraid to set up wireless in case that would mean I could only print wirelessly, which is likely not true. I might (rarely) choose to print from my iPad or iPod wirelessly...

jswaney by Apprentice
  • 8041 Views
  • 6 replies
  • 0 likes

MX472 not getting an ip address

  I got a new Cannon Mx472.  I am able to get it to connect to my wireless network via standard mode (as well as access point method). The issue is when I look on my router I see the printer listed but the ip address is 0.0.0.0.  I have disconnected ...

Getting started

New to the community? Here's some information to help you get acquainted:

Announcements