10-31-2015 11:27 AM
I just completed wirelss setup for our new MX470 printer, the setup worked fine, the test print was successful. The user registration was supposed to complete automatically but it did not connect. The error message said to try again later, I see no connectivity issues.
Is there a setting that may be preventing this? Should I just go to Canon Website and register manually?
11-01-2015 04:02 PM
You can, or just forget it. Registration isn't critical.
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
EOS 1DX Mark III - Version 1.9.0
12/05/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.3.0
07/31/2023: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.