02-22-2023 10:05 PM
I've been using the imageClass D570 for a while now. I primarily use it to print size #10 envelopes from the multi-purpose tray. However, I've run into an extremely frustrating issue. When printing envelopes from the multi-purpose tray through Microsoft Word, it always prints from the primary tray, and tells me to remove paper from the multi-purpose tray. I can print 6 inch envelopes just fine from that tray, but it refuses to print size #10 from the correct tray.
I have configured the MP tray to use Size 10 paper, I have configured Microsoft Word to use the MP tray. Any assistance would be greatly appreciated.
03-20-2023 01:52 PM
Hello FaryaWolyo,
We would be happy to assist with the issue. To provide some feedback or some troubleshooting steps, we would need some additional information. If you could reply to this message with the information below, we can provide some assistance. For a more immediate resolution, you can contact support over the phone at 1-800-652-2666.
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
EOS 1DX Mark III - Version 1.9.0
12/05/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.3.0
07/31/2023: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.