Canon Pixma MG5620 Grayscale Printing
Hi,I have recently bought a Canon Pixma MG5620 and I am unable to figure out how to use grayscale printing. I am using a Mac, version 10.10.3 and I am connected via USB.Thank you
Hi,I have recently bought a Canon Pixma MG5620 and I am unable to figure out how to use grayscale printing. I am using a Mac, version 10.10.3 and I am connected via USB.Thank you
I've cleaned the heads and printed a test sheet - it's fine but it will not actauly print the paper
I haven't had the MG3520 printer a month. I got a error message 5100, which I never had a jam, I made sure everything was clear. I turned off the printer and turned it back on, and still error message. I unplugged it for about 10 min, and turned it b...
Printer: MP800OS: Windows 10 x64Error: "Cannot communicate with the printer. Turn Enable bi-directional support on in the printer's Properties dialog box" Have ticked checkbox in printer settings to enable this but it keeps getting reset.Downloaded l...
Hi,my canon printer is leaving black marks in the corners of photos. Please advise..
I received an error U051. Any suggestions on how to fix?
Earlier I posted a thread with a question regarding Ailignment, but I think I over complicated the question. Does anyone know how I can print a 3.75" x 5.75" on a 4x6 card?
I need to reinstall my printer as it stopped responding but I can't find the installation cd. What can I do?
my printer is an mx882. the error message says to disconnect and contact the service center. I think it said error 200 or maybe 220
I have a Canon MX922 and for some reason when I print envelopes it only prints every second one. I've googled about this and I haven't found anything, am i just a little slow? Can anyone help on this? Thanks.
Whenever I scan using my MX922 with the document feeder on top, the final scanned page is crooked within the document. That is, everything on the page is about 10 degrees off horizontal, including the visible bottom edge of the scanned document. Is t...
I have a Canon MX882 All in one printer that has recently started using up my cyan and magenta ink, but I am only printing in grayscale. Is this a print head problem?
Subject | Author | Posted |
---|---|---|
04-24-2024 10:59 AM | ||
04-23-2024 09:51 PM | ||
04-23-2024 08:22 AM | ||
04-22-2024 09:31 PM | ||
04-22-2024 07:23 PM |
New to the community? Here's some information to help you get acquainted:
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
EOS 1DX Mark III - Version 1.9.0
12/05/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.3.0
07/31/2023: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.