08-23-2022 10:34 AM
I read about the Pixma cycling issue and I have the same trouble with my MX452. It worked fine until yesterday, August 22, 2022. I started printing wirelessly and after the first page printed the printer started beeping and cycling on and off. It will not remain on. I read many of the posts about this same issue on other Pixma printers and tried many of the offered solutions including powering off and recycling both my modem and router as well as disconnecting the printer from power and the USB cable to my iMac... nothing worked. Any additional suggestions to correct this issue will be appreciated. The Canon service message from June 2022 did not include the MX452 in the list of affected printers.
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
EOS 1DX Mark III - Version 1.9.0
12/05/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.3.0
07/31/2023: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.