11-14-2024 08:31 PM - last edited on 11-16-2024 02:08 PM by Danny
I’ve read that I can remove the print head of a Canon MX922 printer and wash it in a windex/warm water solution. Is this correct or will it damage the head?
11-26-2024 04:51 PM - last edited on 11-26-2024 04:52 PM by SamanthaW
Hi Krm0258,
Performing anything other than printhead cleanings or printhead deep cleanings available through the menus on your PIXMA MX922 or from within the printer driver could damage the printhead. Therefore it is not recommended that the printhead is soaked in any solution.
What is the issue that you are experiencing?
Please note, Canon's Forum is not intended for immediate help, but a place to allow for the Community to give you assistance and feedback. For a quicker response, please use the link below to reach our Technical Support Team:
https://mycanon.usa.canon.com
Once logged in, click on your PIXMA MX922 and then click on the Product Support button. When that page loads, click on either the Phone Support button or the Chat Support button to access support.
Did this answer your question? If so, please click the Accept as Solution button below so that others may find the answer as well.
09/26/2024: New firmware updates are available.
EOS R5 Mark II - Version 1.0.1
EOS R6 Mark II - Version 1.5.0
07/01/2024: New firmware updates are available.
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.