12-16-2019 06:29 PM
Trying to connect my mx492 to the router but when I follow directions after finding my router and clicking OK twice it goes into search mode without allowing me to enter password to connect to router. Once I find the router how do i set the password? How do I stop it after pressing the go twice?
12-18-2019 01:30 PM
Hi Handsomehary,
Some routers will not allow for the connection of the printer via manual connection. Instead, please use the WPS PIN Code method. For information on this, please follow the steps in this article:
https://support.usa.canon.com/kb/index?page=content&id=ART173515
12-18-2019 02:46 PM
It won't connect via WPS. i was told that because it was connect to a different router that I had to connect to a computer and run the software over again and then run it wireless
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
EOS 1DX Mark III - Version 1.9.0
12/05/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.3.0
07/31/2023: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.