04-19-2018 07:57 PM
I just purchased the MX492 printer. I have gone through the cableless setup many time. I even entered my password for my wireless connection. It said it was connected. When I go through setup, it continues not to find the printer on the network. It keeps giving me this message at the end:
Failed to perform cableless setup. Suspend the process and select other setup method by following the instructions on the screens.
What am I missing here? It shows connected but not showing up during setup. Thanks in advance.
04-21-2018 07:42 AM
Have you followed these steps?:
The printer should be connected to a 2.4Ghz wireless broadcast.
04-22-2018 08:21 AM - edited 04-23-2018 11:12 PM
I understand the software setup does not complete. Whats does the router show at the end of this process? Log in and look at connected devices. Does the printer apear? If it is indeed connected, it will appear with an IP address under connected devices. If you know the IP, try logging into the printer's webserver... just enter its IP address into your browser.
Another possibility... are you running anti virus software? There is a chace it might conflict with the printer's set up.
What I'm trying to verify is where the problem lies. With the network connection or on the computer?
What is the brand/moodel of your router?
What OS are you running on your computer?
Antivirus if installed?
05-02-2018 07:26 AM
Were you able to get your PIXMA MX492 working wirelessly? If not, please contact our support group using the following link:
11-29-2018 12:39 AM
HI I'm having the same problem!! My MX 294 is connected to internet but cannot be found on my Majove OS Mac...
It was working until i recently ran a couple anti-viral software. How do I get it to work again?
I used Combo Cleaner and Malwarebytes to deep clean my computer recently....
12-04-2018 10:23 AM
Based on your description, it look like the printer was blocked after running the anti-virus software. I would recommend contacting the creator of the anti-virus software to have them deactivate any blocks that are preventing the communication to the printer.
Did this answer your question? Please click the Accept as Solution button so that others may find the answer as well.