Canon Community Canon Community
 


Reply
New Contributor
Posts: 2
Registered: ‎07-20-2015
Accepted Solution

MX410 does not scan wirelessly using Mac

Hi,

 

Recently I was forced to set up a new user on my Mac (OSX Yosemite) and since then the scanner on my MX410 does not work wirelessly. I get the message:

Cannot scan for these reasons:

-Scanner is turned off.

-USB cable is disconnected.

 

Please check and try again.

Scanner driver will be closed.

2.156.0

 

If I change users to the older user, it works just fine. Also if I go into System Pref/Printers & Scanners/Scan/Open Scanner it scans fine wirelessly.

 

Any suggestions or recommendations?

 

Thanks

Super Contributor
Posts: 188
Registered: ‎10-02-2014

Re: MX410 does not scan wirelessly using Mac

Are you using MP Navigator EX or ImageCapture? If you're using MP Navigator, make sure you check the settings on the new users to make sure it's looking for the network version of the scanner.

http://kbsupport.cusa.canon.com/system/selfservice.controller?CONFIGURATION=1011&PARTITION_ID=1&secu...
Highlighted
New Contributor
Posts: 2
Registered: ‎07-20-2015

Re: MX410 does not scan wirelessly using Mac

Thank you very much @merrymary247. The link you sent was very helpful and sorted me out. It seems in MP Navigator EX the selected scanner was MX410 instead of MX 410 Network. When looking at the Preferences I would see MX410 and think it is the correct one and would not bother to investigate further!

 

Thanks again.

powered by Lithium

LIKE US on Facebook FOLLOW US on Twitter WATCH US on YouTube CONNECT WITH US on Linkedin WATCH US on Vimeo FOLLOW US on Instagram SHOP CANON at the Canon Online Store
© Canon U.S.A., Inc.   |    Terms of Use   |    Privacy Statement