05-12-2021 12:48 PM
I have an MG5220 which worked fine yesterday - but powered down and now only picks up my neighbors wireless signal - It does not find my wireless signal and when attempting to direct enter the signal name - cannot connect/find.
Any thoughts?
Solved! Go to Solution.
06-04-2021 02:01 PM
Hi wlpotter,
Please turn your PIXMA MG5220 off and then disconnect the power cord to your router. Wait 1 minute and then reconnect the power cord to your router. Once the router is back online, turn your PIXMA MG5220 on and follow the steps in this article to connect your PIXMA MG5220 to your network:
https://support.usa.canon.com/kb/index?page=content&id=ART137420
06-04-2021 02:01 PM
Hi wlpotter,
Please turn your PIXMA MG5220 off and then disconnect the power cord to your router. Wait 1 minute and then reconnect the power cord to your router. Once the router is back online, turn your PIXMA MG5220 on and follow the steps in this article to connect your PIXMA MG5220 to your network:
https://support.usa.canon.com/kb/index?page=content&id=ART137420
06-04-2021 02:22 PM
Thank you very much.
We actually had a power outage - taking out my router and neighbors - and I was able to connect to my router the next day.
Thanks again
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
EOS 1DX Mark III - Version 1.9.0
12/05/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.3.0
07/31/2023: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.