09-12-2017 02:14 PM
I turned on the power to my Canon MG5220 to print from Windows 10 Dell laptop. Instead of printing as it usually does, the green and yellow light on my printer started blinking alternately for about 20 seconds, paused momentarily, then started blinking alternately again, repeat, repeat. The printer's message box says 'B200, Printer error has occurred, unplug the power cord and call the service center." So,the power cord is unplugged and here I am. What to do?
09-13-2017 04:09 AM
Hi canonhelp,
The B200 error is an indication that your PIXMA MG5522 is experiencing an internal error. Based on this, your PIXMA MG5522 would require service.
It is recommended that you contact one of Canon's Technical Support Representatives. To contact a Technical Support Representative, please use the link below:
http://Canon.us/ContactLI
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
EOS 1DX Mark III - Version 1.9.0
12/05/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.3.0
07/31/2023: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.