Canon Community Canon Community
 


Reply
New Contributor
Posts: 2
Registered: ‎01-23-2018

[EDSDK] How to reset camera after error.

[ Edited ]

Hello, I have following problem when I control camera through EDSDK: if camera fails to shoot after EdsSendCommand, for example if autofocus fails, then it will return "device is busy" error for any subsequent commands. Is there any way to bring camera back to working state except for physically turning it off and on again?

Esteemed Contributor
Posts: 3,402
Registered: ‎02-17-2016

Re: [EDSDK] How to reset camera after error.

I don't know if anyone can anser that, unless Canon chimes in.

New Contributor
Posts: 2
Registered: ‎01-23-2018

Re: [EDSDK] How to reset camera after error.

[ Edited ]

There is always a chance, that someone was working with canon sdk and found answer.

Highlighted
New Contributor
Posts: 1
Registered: ‎01-11-2019

Re: [EDSDK] How to reset camera after error.

[ Edited ]

Hello,

I have the same problem.

Do you know how resolve this ?

Thank you for your response.

powered by Lithium

LIKE US on Facebook FOLLOW US on Twitter WATCH US on YouTube CONNECT WITH US on Linkedin WATCH US on Vimeo FOLLOW US on Instagram SHOP CANON at the Canon Online Store
© Canon U.S.A., Inc.   |    Terms of Use   |    Privacy Statement