08-22-2022 06:41 PM
One computer "upgraded" to Windows 11, and another new Windows 11 computer. I swear I have scanned on both since the change to W11. Since the computers did not have the drivers or app installed I did that. Capture On Touch V4 Pro. As of a couple of days ago when I hit Scan, and the power was on, get the message "Scanner is not ready. (Power may have been cycled.) Try operation again. (-4400) Hitting OK gets the same message back over and over. Turning off the power will allow you to clear the error message. Now I find I do not even need to have the app running to get the error message if I turn on the power to the unit.
10-22-2022 11:41 AM
So we are now about a month out since I applied this "fix." It still works!!
I hope everyone else that has had this problem gets the same results.
09-27-2022 03:52 PM
The solutions I have found are:
I also recommend checking USB ports and disable "Allow the computer to turn off this device to save power". Someone at Canon told me that not only data goes over the USB but some power does too.
We have been doing this with the DR-M140 and DR-2580C. I also put the software (CapturePerfect or CaptureOnTouch) into compatibility mode for Windows 8.
09-27-2022 03:58 PM
Thanks for the tips, and I will try the Allow computer to turn off the device as well as the Compatibility mode. I have verified the registry and yes restarted, and now currently disabled the WIA service. Done everything else, so far, and yes the disabling of the WIA service works, but not a good answer as it may be needed at some point.
05-10-2023 11:03 PM
This is a firmware bug for Canon Scanners. To temporarily fix this issue we need to set the date and time backwards to be able to scan again.
05-10-2023 11:08 PM
To everyone experiencing this issue just change your current date and time backwards to be able to temporarily use the scanner.
09/26/2024: New firmware updates are available.
EOS R5 Mark II - Version 1.0.1
EOS R6 Mark II - Version 1.5.0
07/01/2024: New firmware updates are available.
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.