cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

imagePROGRAF PRO-300- Banding at the start and end of Print

AltamiraDan
Apprentice

Hi, wonder if anyone can help me i've noticed on my prints, that I'm getting some banding at the start of the print and at the end, but not as heavy at the start, I've run a clean on the print nozzles and the rollers.. but still the same, has anybody else come across this problem

 

458225361_10229204366028486_6665105697598850930_n.jpg

2 REPLIES 2

BartHal
Apprentice

I just started getting this problem. Any ideas?

Patrick
Product Expert
Product Expert

Hi AltamiraDan,

Please contact one of Canon's Technical Support Representatives via phone. To contact a Technical Support Representative, please use the link below to log into your My Canon account:

https://mycanon.usa.canon.com

Once logged in, click on your product and then click on the Product Support button. When that page loads, click on either the Phone Support button to access support.

 

 

 

Did this answer your question? Please click the Accept as Solution button so that others may find the answer as well.
Avatar
Announcements